![]() ![]() If you're not skilled in electrical work, this is the job of an electrician. If there's wiring in the wall, you'll need to reroute this wiring to above or below the opening. If you're creating a complete opening to another room and have determined you don't have any weight-bearing walls, then you can use the reciprocating saw to cut the studs in the wall. Continue until all lathing has been removed. Remove all nails from the studs as you go and drop them into an old can so you know where they are and won't step on one. Use your pry bar to hook under the lath strips that are exposed and pull them away from the studs to which they're nailed. If you are opening an entire area, like to create a doorway, then do the other side of the wall. Keep hitting the plaster with the hammer until it is all broken up and falling from the lath. Using your hammer, hit the plaster hard enough to crack it and start it to crumble. Plaster sags from ceilings or bulges from walls when the plaster keys embedded around the wood lath break loose. If the screw cracks the plaster as it goes in, predrill through the plaster. Turn off the electricity to that area at your breaker box or fuse box so if there's wiring in the wall you won't run the risk of electrical shock. Pull loose plaster tight to the lath with plaster washers. Make First HitsÄetermine the exact area you want to remove and mark it with a pencil or chalk. Turn off the fans on your air conditioner or furnace also. You may also want to use plastic drop cloths to seal off doorways to other rooms so the dust won't travel to other parts of the house. It would also be wise to move as much furniture and accessories as possible from the room to a safer spot, or to at least cover them with drop cloths. Put down your drop cloths to protect your floors because this is a very messy, dusty, dirty project. If you're removing part of a wall to install a door, half wall, breakfast bar, or pass-thru, you'll be fine. I would advise to remove all old lath and plaster, re-plasterboard. ![]() While in many cases these types of ceiling can be left well alone, providing they are in sound. Many renovators and owners of older properties will discover lath and plaster ceilings when they come to remodel and decorate their homes. This may be more of a job than you can take on, so you may want to hire a contractor. wall likely crumble when the lining paper and skirting boards are removed. Lath and plaster ceilings and walls were common in houses built from the 1700s right up until the early 1900s. If you are removing a load-bearing wall, you need to be skilled enough to build a header to support the weight of the rafters and roof above. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |